Do the same with the other nut and make sure it's snug against the mounts before you torque them up. Offer the cross member up to the box (which is sitting about 3" low) and poke the socket through to put the nut on. Put a nut in your socket, and stick the spring washer to it with grease. This will force the engine and gearbox forwards slightly, but don't worry about that. Step 3: With the mounts and snubber bolted to the box, drop the lump back in the car and leave the back of the gearbox sitting on the welded-in cross member (is this called a cruciform member?). Modified MGB Transmission Crossmember, both sides drilled for wrench access to gearbox mounts (Alternatively, you could put your extension through the new hole and then attach the socket, reducing the size of the required hole) This picture shows a close-up of the oval stud hole in front, with the hole for the socket behind it. These don't need to be oval of course, as your extension is narrower than the socket and you can tilt it over just fine once you've pushed the socket through. Step 2: Drill two holes on axis with the two studs (in the regular position) in the main part of the cross member, big enough to get your 1/2" socket through (about 7/8"). Step 1: Make the holes for the studs on the rubber mounts oval (about 2.5 times as long as they are wide) so that it can be passed over the studs when the mounts are on the box. I just offer this here for the sake of completeness. Please note that I didn't invent this mod, I have read about it in many places and other descriptions are better than mine I'm sure. Seeing how I seem to need to remove my engine and gearbox on a regular basis (some would comment on my driving style at this point), I decided that this mod was for me, and I took some photos once I'd done it so others can see how easy it is. This is highly advantageous as it is much easier to bolt the mounts and snubber to the gearbox when it is on the bench, and you can get to the bolts from all angles. Jan 02 British Motor Club Of Oregon M.Ī common upgrade to the MGB gearbox crossmember is to remove some metal to enable it to be fitted to mounts already in place on the gearbox, rather than having to bolt the mounts to the cross member first.Jan 03 MGC Day Tour To The Coast Octo.
0 kommentar(er)
